MacDon FlexDraper FD1 Series, Operator'S Manual, Page: 255 / 510

HEADER ATTACHMENT/DETACHMENT
NOTE:
Some parts are removed from the illustration for clarity.
1. Remove bolts (A) and access cover (B) from the
right-hand side of the auger. Retain for reassembly.
2. Remove hardware (C) and bolt-on fl ighting (D) from
the auger.
3. Remove the fl ighting slot plug (E) located close to the
end of the fl ighting (D).
4.
Converting from Configuration A:
Repeat above
steps for the other bolt-on fl ighting on the same side.
Figure 4.30: Configuration C (RH Side)
5.
Converting from Configuration C:
Remove bolts (A),
access cover (B), and two fl ighting slot plugs (C) from
the right-hand side of the auger.
6. Repeat Steps
1., page 237
to
5., page 237
at the
left-hand side of the auger.
Figure 4.31: Configuration C (RH Side)
7. Position two bolt-on fl ightings (MD #213361) (A) on
the right-hand side, as shown. Temporarily secure
fl ightings with two carriage head bolts (MD #184657)
and nuts (MD #135799) at each location (B).
Figure 4.32: RH Side of Auger
147831
237
Revision A