8. Select LEFT SEN (A). The exact voltage is displayed.
Raise and lower the header to see the full range of
voltage readings.
Figure 3.148: Case 8010 Combine Display
9. If the sensor voltage is not within the low and high
limits, or if the range between the low and high limits is
insuf
fi
cient, adjust the voltage limits. Refer to
Voltage Limits (One-Sensor System), page 106
.
Figure 3.149: Case 8010 Combine Display
Checking Voltage Range from the Combine Cab (Case IH 5130/6130/7130, 7010/8010;
7120/8120/9120; 7230/8230/9230)
NOTE:
Changes may have been made to the combine controls or display since this document was published. Refer to
the combine operator’s manual for updates.
CAUTION
Check to be sure all bystanders have cleared the area.
1. Position the header 6 in. (150 mm) above the ground, and unlock the
fl
oat module
fl
oat.
147831
115
Revision A
Summary of Contents for FlexDraper FD1 Series
