11. Follow the calibration steps in the order in which they
appear in the dialog box. As you proceed through
the calibration process, the display will automatically
update to show the next step.
NOTE:
Pressing the ESC key during any of the steps
or letting the system sit idle for more than three
minutes will cause the calibration procedure
to stop.
NOTE:
Refer to your combine operator’s manual for an
explanation of any error codes.
Figure 3.165: Case IH Combine Display
12. When all steps have been completed, CALIBRATION
SUCCESSFUL message is displayed on the page. Exit
the CALIBRATION menu by pressing the ENTER or
ESC key.
NOTE:
If
fl
oat was set heavier to complete ground
calibration procedure, adjust to recommended
operating
fl
oat after the calibration is complete.
13. If the unit does not function properly, conduct the
maximum stubble height calibration.
Setting Preset Cutting Height (Case 7010/8010, 7120/8120/9120, 7230/8230/9230)
To set the preset cutting height, follow these steps:
NOTE:
Changes may have been made to the combine controls or display since this document was published. Refer to
the combine operator’s manual for updates.
1. Engage separator and header.
2. Manually raise or lower the header to the desired
cutting height.
3. Press the SET #1 switch (A). The HEADER HEIGHT
MODE lamp (C), next to the SET #1 switch, turns on.
4. Manually raise or lower the header to a second desired
cutting height.
5. Press the SET #2 switch (B). The HEADER HEIGHT
MODE lamp (D), next to the SET #2 switch, turns on.
Figure 3.166: Case Combine Controls
147831
122
Revision A
Summary of Contents for FlexDraper FD1 Series
