2. Operate the hydraulics to move the reel to the desired
position while using the decal (A) as a reference.
3. Check the reel clearance to cutterbar after making
changes to the cam setting. Refer to the following for
measurement and adjustment procedures:
•
5.13.1 Reel Clearance to Cutterbar, page 404
•
IMPORTANT:
Operating with the reel too far forward can result in
the
fi
ngers contacting the ground. When operating
with the reel in this position, lower the skid shoes or
adjust the header tilt as required to prevent damaging
the
fi
ngers.
Figure 3.90: Fore-Aft Decal
147831
83
Revision A
Summary of Contents for FlexDraper FD1 Series
