Installing Header Draper Idler Roller
1. Position the stub shaft into the idler roller in the forward
arm (B) on the deck.
2. Push on the roller to slightly de
fl
ect the forward arm so
the stub shaft at the rear of the roller can be slipped
into the rear arm (C).
3. Install bolts (A) with washers, and torque to 70 ft
·
lbf
(93 N
·
m).
4. Wrap the draper over the idler roller, close the draper,
and set the tension. Refer to
5. Run the machine and verify the draper tracks correctly.
Adjust the draper tracking if required. Refer to
Adjusting Header Draper Tracking, page 390
.
Figure 5.184: Idler Roller
Draper Deck Drive Roller
Removing Header Draper Drive Roller
DANGER
To avoid bodily injury or death from unexpected start-up or fall of a raised machine, always stop engine
and remove key before leaving the operator’s seat, and always engage safety props before going under
the machine for any reason.
NOTE:
If the draper connector is not visible, engage the header until the connector is accessible (preferably close to
the outboard end of the deck).
1. Start the engine, raise the header, and raise the reel.
2. Stop the engine, and remove the key from the ignition.
3. Loosen the draper by turning the adjuster bolt (A)
counterclockwise.
Figure 5.185: Tensioner
147831
397
Revision A
Summary of Contents for FlexDraper FD1 Series
