MacDon FlexDraper FD1 Series, Operator'S Manual, Page: 163 / 510

OPERATION
10. Press the CAL button (A) to save the calibration of the
header. HDR H-UP appears on the monitor.
11. Raise the header three feet off the ground and press
the CAL (A) button. EOC appears on the monitor.
12. Press the ENTER button (B) to save the calibration of
the header. Your AHHC is now calibrated.
NOTE:
If an error code appears during calibration, the
sensor is out of voltage range and will require
adjustment. Refer to
Checking Voltage Range
from the Combine Cab (John Deere 60 Series),
page 142
.
NOTE:
After the calibration is complete, adjust
combine operation settings to ensure proper
fi eld operation.
Figure 3.204: John Deere Combine Display
Turning the Accumulator Off (John Deere 60 Series)
NOTE:
Changes may have been made to the combine controls or display since this document was published. Refer to
the combine operator’s manual for updates.
1. Press the DIAGNOSTIC button (A) on the monitor. DIA
appears on the monitor.
2. Press the UP button (B) until EO1 appears on
the monitor, and press ENTER (D). This is the
header adjustment.
3. Press the UP (B) or DOWN (C) button until 132 is
displayed on the top portion of the monitor. This is the
reading for the accumulator.
4. Press ENTER (D) to select 132 as the accumulator
reading (this will allow you to change the display to a
three-digit number so it has a 0 in it, for example, x0x).
5. Press the UP (B) or DOWN (C) button until the desired
number is displayed, and press the CAL (E) button.
6. Press ENTER (D) to save the changes.
The
accumulator is now deactivated.
Figure 3.205: John Deere Combine Display
Setting the Sensing Grain Header Height to 50 (John Deere 60 Series)
NOTE:
Changes may have been made to the combine controls or display since this document was published. Refer to
the combine operator’s manual for updates.
147831
145
Revision A