![background image](http://html.mh-extra.com/html/macdon/flexdraper-fd1-series/flexdraper-fd1-series_operators-manual_685695306.webp)
18. Place a 6 in. (150 mm) block (A) under the header leg.
This will assist with disconnecting the center-link.
19. Disengage combine lift cylinder locks, start engine, and
lower header until the header leg rests on the block or
stabilizer wheels are the ground.
Figure 4.146: Header Leg on Block
20. Disconnect the hydraulic center-link as follows:
a. Remove the lynch pin and clevis pin (A), and lift the
center-link (B) clear of the bracket.
b. Replace the clevis pin (A) and secure with
lynch pin.
NOTE:
It may be necessary to raise or lower the feeder
house to adjust the length of the center-link and
relieve excess load on the center-link.
Figure 4.147: Hydraulic Center-Link
NOTE:
• If on the ground: Push reel fully forward to reduce
oil loss.
• If on transport: Pull reel fully back.
21. Disconnect electrical connector (B).
22. Disconnect the case drain, knife, and draper drive
hydraulic hoses at the coupler bracket (A). Cap off
ends immediately to avoid loss of oil.
23. Store and secure hoses on
fl
oat module frame.
Figure 4.148: Header Connections
147831
288
Revision A
Summary of Contents for FlexDraper FD1 Series
