MacDon FlexDraper FD1 Series, Operator'S Manual, Page: 160 / 510

OPERATION
3.8.6 John Deere 60 Series Combines
Checking Voltage Range from the Combine Cab (John Deere 60 Series)
NOTE:
Changes may have been made to the combine controls or display since this document was published. Refer to
the combine operator’s manual for updates.
CAUTION
Check to be sure all bystanders have cleared the area.
1. Position the header 6 in. (150 mm) above the ground, and unlock the fl oat module fl oat.
2. Check that fl oat lock linkage is on down stops
(washer [A] cannot be moved) at both locations.
NOTE:
If the header is not on down stops during the next
two steps, the voltage may go out of range during
operation causing a malfunction of the AHHC system.
Figure 3.199: Float Lock
3. Adjust the cable take-up bracket (B) (if necessary) until
the pointer (A) on the fl oat indicator is on the 0.
Figure 3.200: Float Indicator box
147831
142
Revision A