4.3
Case IH Combines
4.3.1
Attaching Header to Case IH Combine
DANGER
To avoid bodily injury or death from unexpected start-up of machine, always stop engine and remove key
from ignition before leaving operator’s seat for any reason.
1. On the combine, ensure the lock handle (A) is
positioned so the hooks (B) can engage the
fl
oat
module.
Figure 4.45: Feeder House Locks
CAUTION
Never start or move the machine until you are sure all
bystanders have cleared the area.
2. Start the engine and slowly drive the combine up to
the header until the feeder house saddle (A) is directly
under the
fl
oat module top cross member (B).
3. Raise the feeder house slightly to lift the header,
ensuring the feeder saddle is properly engaged in the
fl
oat module frame.
4. Stop the engine and remove the key from the ignition.
Figure 4.46: Combine and Float Module
5. On the left side of the feeder house, lift lever (A) on the
fl
oat module and push handle (B) on the combine to
engage locks (C) on both sides of the feeder house.
6. Push down on the lever (A) so the slot in the lever
engages the handle and locks the handle in place.
7. If lock (C) does not fully engage the pin on the
fl
oat module, loosen bolts (D) and adjust lock.
Retighten bolts.
Figure 4.47: Combine and Float Module
147831
244
Revision A
Summary of Contents for FlexDraper FD1 Series
