10. Lock the wheel (A) with pin (B). Move the right axle (C)
to the front of the header.
Figure 3.359: Right Rear Wheel
11. Remove the pin (A), raise support (B) to the position
shown, and reinsert pin.
IMPORTANT:
Ensure the pin (A) engages the tube on the axle.
12. Swing the brace (C) into the position shown and
insert the brace into the slot (D) behind the cutterbar.
Position the brace so that pin (E) engages the hole
in the bracket (F). The right hand wheel is now in
transport position.
13. Disengage the header cylinder lift stops.
14. Detach
the
header’s
hydraulic
and
electrical
connections from the combine. Refer to
Attachment/Detachment, page 225
.
15. Start the combine and lower the header to the ground.
Figure 3.360: Right Rear Wheel Position
147831
220
Revision A
Summary of Contents for FlexDraper FD1 Series
