MacDon FlexDraper FD1 Series, Operator'S Manual, Page: 349 / 510

MAINTENANCE AND SERVICING
5.7 Auger
The FM100 Float Module auger feeds the cut crop from the draper decks into the combine feeder house.
5.7.1 Adjusting Auger to Pan Clearance
DANGER
To avoid bodily injury or death from unexpected start-up of machine, always stop engine and remove key
from ignition before leaving operator’s seat for any reason.
IMPORTANT:
Maintain an appropriate distance between the auger and the auger pan. Too little clearance may result in the
fi ngers or fl ighting contacting and damaging the feed draper or pan when operating the header at certain angles.
Look for evidence of contact when greasing the fl oat module.
1. Extend the center-link to the steepest header angle, and position the header 6–10 in. (150–254 mm) off
the ground.
2. Lock header wings. Refer to
Locking/Unlocking Header Wings, page 62
.
3. Shut down the combine and remove the key from the ignition.
4. Ensure the fl oat lock linkage is on the down stops
(washer [A] cannot be moved) at both locations.
Figure 5.47: Float Lock
147831
331
Revision A