Repositioning Fore-Aft Cylinders
The reel can be moved approximately 9 in. (227 mm) further aft by repositioning the fore-aft cylinders on the
reel arms. This may be desirable when straight-combining canola. If the Multi-Crop Rapid Reel Conversion option
is installed, refer to
Repositioning Fore-Aft Cylinders with Multi-Crop Rapid Reel Conversion Option, page 87
DANGER
To avoid bodily injury or death from unexpected start-up of machine, always stop engine and remove key
from ignition before leaving operator’s seat for any reason.
Reposition the center arm cylinder as follows:
NOTE:
Reel components not shown in illustration for
improved clarity.
1. Position reel fully aft with support arms horizontal.
2. Stop engine and remove key.
3. Remove four bolts (A) securing cylinder bracket (B) to
reel arm.
4. Push/pull reel until bracket (B) lines up with the fore/aft
set of holes (C).
5. Reinstall four bolts (A) to secure bracket (B) to reel arm
at new position.
Figure 3.91: Forward Position
Figure 3.92: Rearward Position
147831
84
Revision A
Summary of Contents for FlexDraper FD1 Series
