MacDon FlexDraper FD1 Series, Operator'S Manual, Page: 209 / 510

OPERATION
There are now two different buttons for ON GROUND
presets. The toggle switch that was present on previous
models is now con
fi gured as shown at right. MacDon
headers only require the fi rst two buttons (A and B). The
third button down (C) is not con fi gured.
Figure 3.304: New Holland Combine Controls
3.8.12 New Holland Combines (CR Series—Model Year 2015 and Later)
This section applies only to 2015 and later CR models (6.80, 6.90, 7.90, 8.90, 9.90, and 10.90). For other New
Holland combine models, refer to
3.8.11 New Holland Combines, page 181
.
Checking Voltage Range from the Combine Cab (New Holland CR Series)
NOTE:
Changes may have been made to the combine controls or display since this document was published. Refer to
the combine operator’s manual for updates.
CAUTION
Check to be sure all bystanders have cleared the area.
1. Position the header 6 in. (150 mm) above the ground, and unlock the fl oat module fl oat.
147831
191
Revision A