MacDon FlexDraper FD1 Series, Operator'S Manual, Page: 187 / 510

OPERATION
8. Brie fl y press button (A) or button (B) in order to select
the set point.
9. Repeat Step
7., page 168
for the set point.
Figure 3.256: Joystick Buttons
Setting Cutting Height Manually (Lexion 500 Series)
CAUTION
Check to be sure all bystanders have cleared the area.
NOTE:
Changes may have been made to the combine controls or display since this document was published. Refer to
the combine operator’s manual for updates.
1. Use button (A) to raise the header or button (B) to lower
the header to the desired cutting height.
2. Press and hold button (C) for three seconds to store
the cutting height into the CEBIS (an alarm will sound
when the new setting has been stored).
3. Program a second set point, if desired, by using
button (A) to raise the header or button (B) to lower
the header to the desired cutting height, and brie
fl y
press button (C) to store the second set point into the
CEBIS (an alarm will sound when the new setting has
been stored).
NOTE:
For above the ground cutting, repeat Step
1.,
page 169
, and use button (D) instead of
button (C) while repeating Step
2., page 169
.
Figure 3.257: Joystick Buttons
147831
169
Revision A