1. Wipe grease
fi
tting with a clean cloth before greasing
to avoid injecting dirt and grit.
2. Inject grease through
fi
tting with grease gun until
grease over
fl
ows
fi
tting (except where noted).
3. Leave excess grease on
fi
tting to keep out dirt.
4. Replace any loose or broken
fi
ttings immediately.
5. Remove and thoroughly clean any
fi
tting that will
not take grease. Also clean lubricant passageway.
Replace
fi
tting if necessary.
6. Use clean,
high-temperature,
extreme-pressure
grease only.
Figure 5.15: FM100 Master Grease Point Decal
Lubricating Reel Drive Chain
DANGER
To avoid bodily injury or death from unexpected start-up of machine, always stop engine and remove key
from ignition before leaving operator’s seat for any reason.
1. Stop the engine and remove the key from the ignition.
2. Remove six bolts (A) securing the upper cover (B) to
the reel drive and lower cover (C).
Figure 5.16: Drive Cover
3. Remove three bolts (A) and remove the lower cover
(B), if necessary.
Figure 5.17: Lower Drive Cover (Upper Cover
Removed)
147831
314
Revision A
Summary of Contents for FlexDraper FD1 Series
