MacDon FlexDraper FD1 Series, Operator'S Manual, Page: 310 / 510

HEADER ATTACHMENT/DETACHMENT
CAUTION
Always connect center-link before fully
raising header.
10. Match the colored cable ties and connect the reel
hydraulics (A) at the right end of the fl oat module.
CAUTION
Be sure all bystanders are clear of machine before
starting engine or engaging any header drives.
11. Start the engine and slowly raise the fl oat module
while making sure the fl oat module legs engage the
header legs.
12. Raise the header to its full height, stop the engine, and
remove the key from the ignition.
13. Engage the header lift cylinder stops on the combine.
Figure 4.157: Reel Hydraulics
14. Loosen nut and bolt (A), and reposition hook (B) as
shown to engage fl oat module arm. Tighten bolt and
nut (A).
CAUTION
Be sure all bystanders are clear of machine before
starting engine or engaging any header drives.
15. Remove the lift cylinder locks, start the engine, and
lower the header to the ground. Adjust the header
angle to the shallowest setting (shortest center-link).
16. Raise the reel to its full height.
17. Shut down the engine and remove the key from
the ignition.
18. Engage the reel safety props.
Figure 4.158: Float Module Underside
WARNING
Keep hands clear of the area between guards and
knife at all times.
Figure 4.159: Cutterbar Hazard
147831
292
Revision A