3. Loosen the two bolts (A) securing the motor assembly
to the header endsheet.
4. Turn the adjuster bolt (B) clockwise to move the drive
motor until a force of 30 lbf (133 N) de
fl
ects the belt (C)
61/64–1-3/32 in. (24–28 mm) at the mid-span.
Figure 5.123: Left-Hand Shown – Right-Hand
Opposite for Double-Knife Headers
5. Ensure the clearance between the belt (A) and the belt
guide (B) is 3/64 in. (1 mm).
6. Loosen the three bolts (C), and adjust the position of
the guide (B) as required.
7. Tighten the three bolts (C).
8. Close the endshield. Refer to
NOTE:
Readjust the tension of a new belt after a short
run-in period (about
fi
ve hours).
9. Repeat procedure on the other side of the header.
Figure 5.124: Knife Drive
147831
370
Revision A
Summary of Contents for FlexDraper FD1 Series
