MacDon FlexDraper FD1 Series, Operator'S Manual, Page: 430 / 510

MAINTENANCE AND SERVICING
NOTE:
If replacing only the cam end bushing, refer to Step
8., page 413
.
Center Disc and Tail-End Bushings
3. Remove the reel endshields and endshield support (C)
from the tail end of the reel at the applicable tine
tube location.
NOTE:
There are no endshields on the center disc.
4. Remove bolts (A) securing arm (B) to the disc.
IMPORTANT:
Note the hole locations in the arm and disc and
ensure the bolts (A) are reinstalled at the original
locations.
Figure 5.216: Tail End
5. Release the bushing clamps (A) using a small
screwdriver to separate the serrations. Pull the clamp
off the tine tube.
Figure 5.217: Bushing Clamp
6. Rotate the arm (A) until clear of the disc and slide the
arm inboard off of bushing (B).
7. Remove the bushing halves (B). If required, remove
the next tine or plastic fi nger so the arm can slide
off the bushing. Refer to the following procedures as
necessary:
•
Removing Plastic Fingers, page 410
•
Removing Steel Fingers, page 409
Figure 5.218: Bushing
147831
412
Revision A