![background image](http://html.mh-extra.com/html/macdon/flexdraper-fd1-series/flexdraper-fd1-series_operators-manual_685695422.webp)
5.13
Reel
CAUTION
To avoid personal injury, before servicing machine or opening drive covers, refer to
.
5.13.1
Reel Clearance to Cutterbar
The minimum clearance between the reel
fi
ngers and the cutterbar ensures that the reel
fi
ngers do not contact
the cutterbar during operation. The clearance is adjusted at the factory, but some adjustment may be necessary
before operation.
The
fi
nger to guard/cutterbar clearances with reels fully lowered are shown in Table
IMPORTANT:
Measurements must be taken at
both ends of each reel and at the cutterbar flex locations
with the header
in full-frown mode.
Table 5.3 Finger to Guard/Cutterbar Clearance
Header Width
(X) +/- 1/8 in. (3 mm) at Reel
Ends and Flex Locations
30 ft.
35 ft.
40 ft.
45 ft.
3/4 in.
(20 mm)
Figure 5.199: Finger Clearance
Measuring Reel Clearance
DANGER
To avoid bodily injury or death from unexpected start-up or fall of raised machine, always stop engine,
remove key, and engage safety props before going under header for any reason.
1. Park the header on level ground.
147831
404
Revision A
Summary of Contents for FlexDraper FD1 Series
