Keysight Technologies D9020DDRC, Manual

Page: 84 / 370

4 Single-Ended Signals AC Input Parameters Tests
68 DDR2(+LP) Compliance Testing Methods of Implementation
V
IH(DC)
Test for Address, Control - Test Method of Implementation
V
IH(DC)
- Minimum DC Input Logic HIGH for Address, Control.
The purpose of this test is to verify that the mode of histogram of the high level voltage value of the
test signal within a valid sampling window is within the conformance limits of the V
IH(DC)
value
specified in the JEDEC specification.
The value of V
REF
which directly affects the conformance lower limit is set to 0.9V. User may choose
to use the UDL (User Defined Limit) feature in the application to perform this test against a
customized test limit set based on the different values of V
REF
.
The value of V
DDQ
which directly affects the conformance upper limit is set to 1.8V. User may choose
to use the UDL (User Defined Limit) feature in the application to perform this test against a
customized test limit set based on the different values of V
DDQ
.
Signals of Interest
Mode Supported: DDR2 only
Signal cycle of interest: WRITE
Required Read/Write separation: No
Signal(s) of Interest:
• Address Signals OR
• Control Signals OR
• Clock Signals
Signals required to perform the test on the oscilloscope:
• Pin Under Test, PUT - any of the signal of interest defined above.
Test Definition Notes from the Specification
Test References
See Table 19 - Input DC Logic Level, in the JEDEC Standard JESD79-2E and Table 19 - Input DC
Logic Level in the JESD208 .
Table 37 Input DC Logic Level
Symbol Parameter Min Max Units Notes
V
IH(DC)
DC input logic HIGH V
REF
+ 0.125 V
DDQ
+ 0.3 V -
Table 38 Input DC Logic Level (DDR2-1066)
Symbol Parameter Min Max Units Notes
V
IH(DC)
DC input logic HIGH V
REF
+ 0.125 V
DDQ
+ 0.3 V -