Juniper JUNOS OS 10.3 - SOFTWARE, Manual

Page: 3679 / 3946

udp-port 5600;
sample-rate 1000;
collector 10.204.32.46;
interfaces ge-0/0/0.0;
Verification
To confirm that the configuration is correct, perform these tasks:
•
Verifying That sFlow Technology Has Been Configured Properly on page 3583
•
Verifying That sFlow Technology Is Enabled on the Intended Interface on page 3583
• Verifying the sFlow Collector Configuration on page 3584
Verifying That sFlow Technology Has Been Configured Properly
Purpose Verify that sFlow technology has been configured properly.
Action Use the show sflow command:
user@switch> show sflow
sFlow : Enabled
Sample limit : 300 packets/second
Polling interval : 20 seconds
Sample rate : 1:1000
Agent ID : 10.204.96.222
NOTE: The sample limit cannot be configured and is set to 300
packets/second.
Meaning The output shows that sFlow technology is enabled and specifies the values for the
sample rate, sample limit, and polling interval.
Verifying That sFlow Technology Is Enabled on the Intended Interface
Purpose Verify that sFlow technology is enabled on interfaces and display the sampling
parameters.
Action Use the show sflow interface command:
user@switch> show sflow interface
Interface Status Sample rate Adapted sample rate Polling-interval
ge-0/0/0.0 Enabled 1000 16000 20
NOTE: The sample limit cannot be configured and is set to 300
packets/second.
3583 Copyright © 2010, Juniper Networks, Inc.
Chapter 128: sFlow Monitoring Technology