Copyright 2022 Baker Hughes Company.
English–DPI 610E Instruction Manual | 13
Safety
1.6.1 General Safety Precautions
•
Use only the approved tools, consumable materials and spares to operate and maintain the
equipment.
•
Make sure all work areas are clean and clear of unwanted tools, equipment and materials.
•
Make sure all unwanted consumable materials are discarded in accordance with local health
and safety and environmental regulations.
1.6.2 Operation in a Hazardous Environment
Refer to the Quick Start and Safety Manual provided with the instrument.
1.6.3 General Warnings
1.6.4 Electrical Warning
Note:
Position the power supply without obstructing the supply disconnecting device.
Note:
The instrument is suitable for short-term and long-term temporary overvoltage that may
occur between the line conductor and earth in electrical installations.
Note:
Keep all leads free from contaminants.
WARNING
Do not use the DPI 610E-HC or DPI 610E-PC in locations where
explosive gas, vapor or dust are present. There is a risk of an explosion.
Make sure that the instrument is safe to use with the proposed media. Some
liquid and gas mixtures are dangerous. This includes mixtures that result from
contamination.
Do not use in an enriched oxygen environment or with other strong oxidizers -
this can cause an explosion.
Do not use tools on the instrument that might cause incendive sparks - this can
cause an explosion.
It is dangerous to ignore the specified limits (refer to data sheet) for the DPI 610E
series or to use the instrument when it is not in its normal condition. Use the
applicable protection and obey all safety precautions.
RISK OF ELECTRIC SHOCK
To prevent electrical shocks or damage to
the instrument, do not connect more than 30 V CAT I between the terminals, or
between the terminals and the ground (earth). Any connection must be
compliant with the terminal input/output parameters.
External circuits should have appropriate insulation to the mains.
WARNING
This instrument uses a Lithium-Ion (Li-Ion) battery pack. To
prevent an explosion or fire, do not short circuit and do not disassemble. Keep
the battery safe from damage.
WARNING
To prevent an explosion or fire, only use the Druck specified
battery (150M8295-1) and power supply (149M4334-1) rated for this instrument.
To prevent battery leakage/damage or excess heat generation, only use the
mains power supply in the ambient temperature range 0 to 40°C (32 to 104°F).
The power supply input range is 90 – 264 VAC, 50 to 60 Hz, 300 mA, installation
category CAT II.
