Copyright 2022 Baker Hughes Company.
180 | DPI610E Instruction Manual–English
Chapter 11. Documenting
11.2.2 How to create an Internal Procedure
Step 1
This screen appears after
INTERNAL
PROCEDURES
has been selected from
the
Procedures
screen (see
Section 11.2.1 on page 179).
The
Internal Procedure Files
screen
shows the list of available internal
procedure files. The number of Assets on
which each procedure has been run and
calibration results saved will also be shown
alongside the Procedure file name.
See Section 11.2.3 on page 187 on how to
run a test procedure.
If no procedures have been created or
saved, the
Internal Procedures
screen will
be blank.
Select the
New Procedure
Softkey to
start the Procedure Creation wizard.
Step 2
Enter a filename for the test procedure or
use the default filename which is based on
the system date and time stamp.
Note
: A maximum of 20 characters is
supported for the filename.
Select the
Tick
softkey to confirm and
show the
Create
Procedure
screen.
Step 3
Select the type of calibration required.
Proportional
is the default option.
Press the
Next
softkey to proceed or
the
Previous
softkey to go back one
step.
