Copyright 2021 Baker Hughes Company.
94 | DPI610E Instruction Manual–English
Chapter 6. Calibrator Tasks
The other methods to set the current source output are:
1.
Nudge (manual)
2.
Span Check (manual or automated)
3.
Percent Step (manual or automated)
4.
Defined Step (manual or automated)
5.
Ramp (automated).
These methods are explained in this chapter, however, the Configuration Options must first be
set before these methods can be used. Make sure the type of test has been selected (See
Section 3.2 on page 42), to make the required screens be available.
Configuration Options
INFORMATION
Once a target current source value is set, the displayed value will
start to flash. Once the setpoint has been reached, the source value will stop flashing and
remain steady.
Step 1
Tap on the
CH2
window (anywhere
except the Units area) or, if using the
navigation keypad, press the
DOWN
button to select
CH2
, then press the
OK
button to expand the channel window.
Step 2
Select the
Tool
options
icon to
show the
Source Automation
screen
