Copyright 2022 Baker Hughes Company.
English–DPI610E Instruction Manual | 143
PM700E
8.1.3 Setup
Each PM700E sensor is supplied with a 2.9m (9.5 feet) PM700E-CABLE. This cable is for
connection of the sensor to the “EXT SENSOR” port on the side of the DPI 610E. Align the
pin/slot arrangement at the female end of the cable connector with the male connector end of the
sensor. The cable connector should push in with little force when it is correctly aligned. Proceed
to complete the connection by rotating the locking collar until hand tight. Similarly, align the male
end of the cable to the port on the DPI 610E and tighten in the same way.
The DPI 610E automatically detects any connection to a PM700E sensor. Upon successful
connection of a recognised and supported sensor, a “Connected” status indication will appear for
a few seconds in the status bar. Also, the screen will show an
External Sensor
icon
until the
sensor is disconnected (see bottom left of screen image below). When the sensor is
disconnected, a “Disconnected” status indication appears for a few seconds in the status bar and
then the external sensor icon disappears.
