Digi HI-700HS, Service Manual, Page: 62 / 324

HI - 700HS service manual - 2 - component parts
2 - 28 Issue 1 02/2020
Conveyors (HS type) - identification of parts
Conveyor belts
The conveyor shown below is a typical HS conveyor (non scale).
The length and width varies depending on machine specification.
Gearhead - can be either 5:1
or 10:1 depending on machine
specification, check model no.
to identify, the last digit
indicates ratio
DC motor - 50W except
400mm scale which
is 30W
Idler roller
Conveyor belt
tension screws–
see service section
for adjustment
Drive roller
Conveyor location block at
each corner of the deck,
locate these into the pins
With the conveyor belt removed, the anti friction
tape can be seen. There is a number of strips
depending on conveyor deck width. This tape
(UHMWpe) should be check periodically for any
damage or wear
Conveyor location clip bracket
Reflector in deck for overhead pack sensor,
where required.