Digi HI-700HS, Service Manual, Page: 148 / 324

HI - 700HS service manual - 4 – servicing
4 - 39 Issue 2 06/2020
Checksum mismatch error
To overcome this error for Console software go to :
Service menu / scale / ADC settings - (set ADC security switch to OFF to allow entry - see page 4 - 38
for location)
On this screen there are some ADC settings.
Select a value (for this example, FFT bandwidth is used, retype in the same value. In this case, 120
NOTE: MAKE SURE IT IS THE SAME VALUE THAT IS TYPED IN FOR THE CHOSEN PARAMETER.
Press OK and Save on exit, shut machine down and restart to enable scale.
The scale will now function, check all calibration for correct weighing.
This error can be due to the new weighing part (ADC) being fitted and/or change of software installed.
The checksum which is created by the machine will still match the original part/software therefore a new
checksum needs to be established.
Console software - Checksum mismatch
error screen
Worldview software—
Checksum mismatch
error screen
Console software ADC settings
screen
See following page for Worldview