Digi HI-700HS, Service Manual, Page: 119 / 324

HI - 700HS service manual - 4 – servicing
4 - 10 Issue 2 06/2020
Re - assembly - motor pulley grub screw location
Important - the fitting of the motor pulley is slightly different depending if the assembly is for a
standard conveyor or a scale conveyor
Scale motor assembly
The scale motor assembly (shown left) must have a
grub screw in all four positions in the pulley.
Fit an M4x10 grub screw on the opposite side to the
keyway & fit M4x5 grub screws in the other three
positions.
Use Loctite 243
The key supplied with the gearhead must be fitted,
see image below
Standard motor assembly (non scale)
This motor assembly (shown left) has two grub
screws fitted to secure the pulley.
Fit two M4x5 grub screws, one at key position
Use Loctite 243
The key supplied with the gearhead must be fitted,
see image below