Digi HI-700HS, Service Manual, Page: 201 / 324

HI - 700HS service manual - 4 – servicing
4 - 92 Issue 2 06/2020
HS blow applicator setup continued - blow bar air flow
To aid good label placement onto the label receiver, the blow bar should have a suitable air flow set and its
air jet holes positioned at the correct angle for best transfer of label onto the receiver.
Important - the blow bar fitted to the labeller when using the HS blow applicator is a dedicated one for this
applicator - see below
Centre line of label path and applicator
receiver
Blow bar hole positions
Remove rear applicator cover to gain access
to the air restrictor. Adjust this to change the
amount air flow from the blow bar. This may
depend on label size.
Refer to section 2 - component parts for HS
blow applicator pneumatic diagram
The angle of the blow can be adjusted to suit
the label length. A standard setting is shown
left
Use this one with HS
blow applicator
Std blow bar -
not for HS blow
applicator