Digi HI-700HS, Service Manual, Page: 171 / 324

HI - 700HS service manual - 4 – servicing
4 - 62 Issue 2 06/2020
Signature labeller - thermal head horizontal position
Head set up position - wear strip type & platen roller
The head mounting plate (701 - 0021) which is fixed to the labeller back plate with four hex head screws
has a default position which then allows for correct fine horizontal adjustment on the two adjuster screws
NOTE: before setting the head mount plate position, the thermal head horizontal position should
be set using the two adjuster screws to its default position
- see below
Set the thermal head horizontal position to its
default position by turning in/out the two
adjuster screws circled above
The default position is when the two top edges of
the two brackets (head adjustment block & head
mounting bracket) are in line, see circled area
left
This should be equal on both adjuster screws