Digi HI-700HS, Service Manual, Page: 259 / 324

HI - 700HS service manual - 4 – servicing
4 - 150 Issue 2 06/2020
Outfeed sensor for label application position - Console software
settings.
Navigate to Service menu / Labeller(s) /
Labeller 1 (or labeller being setup)
General settings:
Labeller sensor
Window (MS) - set required value here for
the extra sensor window
Sensor distance (mm) - set value here for
distance scale deck to extra sensor (see
image on previous page).
Navigate to Service menu / Labeller(s) /
Labeller 1 (or labeller being setup)
Label parameters
Set application position distance
PLU editor
In the extra equipment tab, select Enabled
for extra sensors.
Select Start pack if label is to be applied at
the leading edge of the pack