Digi HI-700HS, Service Manual, Page: 16 / 324

HI - 700HS service manual - 1 - Installation
1 - 9 Issue 2 06/2020
Installation
Machine feet
Once the machine has had any packaging removed, place the machine in its required position.
Fitting labeller to labeller arm
The labeller may have been removed from the labeller arm for transportation. Replace labeller onto the arm
as follows
-
Remove the end plate and the two M8 cap head screws, Slide the labeller on to the labeller arm
Refit the two M8 screws into the labeller arm and the end plate
With the machine in position, lower the
feet. Level the machine and ensure all
feet are firmly on the solid ground.
If the lifting angles are fitted, these can
be removed
For a HI machine which has two frames,
ensure both frames are level with each
other
Tighten the locking nut on each foot