Altigen AltiContact Manager Version 5.0A, Administration Manual

Page: 528 / 578

E1 R2 CAS Installation
A-2 AltiContact Manager Administration Manual
In the Triton E1Configuration window, check the properties of the E1
trunk and consult your CO for “ Frame Type ,” “ Line Code ,” or “ Zero
Code Suppression .” Do not check the System Clock Master check box
because the CO is a clock provider, and our system is synchronized to the
CO.
CD Bits Handling is selected to "CD = 01". If all configurations are
correct, the status of trunk line should be shown as “ OK .” Figure 1 shows
the proper configuration.
Step 2: Data Link Layer
In the T1/E1 Configuration window, select the switch mode according to
your country in the E1 R2 setting field.
Figure 2. Data Link Layer
Step 3: Signaling Layer
In the Triton E1 Trunk Configuration dialog box, configure the
following fields:
• Set Calling Party Category to - the Calling Party Category
indicates the type of calling party, (e.g. operator, pay phone,
priority, ordinary subscriber). Select
1 , 2 or 3 (for ordinary
subscribers, refer to Table 1). If the subscribed line is intended for
other purposes, contact your CO for the proper value.
• Add extra digits before caller ID - consult your CO to find out if
any extra digits are needed.