Alcatel-Lucent OmniSwitch 6250, Cli Reference Manual, Page: 972 / 2018

LINK OAM Commands
page 26-4 OmniSwitch 6250 CLI Reference Guide November 2009
efm-oam port status
Enables or disables LINK OAM protocol on the specified port or on a range of ports.
efm-oam port slot/port [-port2] status {enable | disable}
Syntax Definitions
slot/port The slot number of the module and the physical port number on that
module.
-port2 Specifies the last port in the range of ports.
enable Enables LINK OAM protocol on the specified port.
disable Disables LINK OAM protocol on the specified port.
Defaults
By default, the LINK OAM protocol is disabled on all ports for the switch.
Platforms Supported
OmniSwitch 6250
Usage Guidelines
•
LINK OAM must be enabled globally for the OAM to be functional on all the ports.
•
If LINK OAM is disabled for the port or globally disabled for the switch, any OAMPDUs received are
discarded.
•
When LINK OAM is disabled for the port, all dynamically learned information on the port, including
peer information, is deleted. However, the LINK OAM configuration for the port is retained.
•
LINK OAM is not supported on the mirroring ports.
•
In link aggregates, LINK OAM is supported on an individual aggregable port only.
Examples
-> efm-oam port 1/1 status enable
-> efm-oam port 1/1 status disable
-> efm-oam port 2/1-10 status enable
-> efm-oam port 2/1-4 status disable
Release History
Release 6.6.1; command was introduced.