Alcatel-Lucent OmniSwitch 6250, Cli Reference Manual, Page: 316 / 2018

SNMP Commands
page 10-20 OmniSwitch 6250 CLI Reference Guide November 2009
snmp trap replay
Replays stored traps from the switch to a specified SNMP station. This command is used to replay (to
resend) traps on demand. This is useful in the event when traps are lost in the network.
snmp trap replay {ip_address | ipv6_address} [seq_id]
Syntax Definitions
ip_address The IP address for the SNMP station to which traps will be replayed
from the switch.
ipv6_address The IPv6 address for the SNMP station to which traps will be replayed
from the switch.
seq_id The sequence number from which trap replay will begin. Each trap sent
by the switch to an SNMP station has a sequence number. The sequence
number reflects the order in which the trap was sent to the SNMP
station. For example, the first trap sent to an SNMP station has a
sequence number of 1; the second trap has a sequence number of 2, etc.
If no sequence number is entered, all stored traps are replayed.
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
•
Use the show snmp station command on page page 10-5 to display the latest stored sequence number
for each SNMP station.
•
The switch replays traps in the same order that they were previously sent, beginning from the specified
sequence number.
•
When traps are replayed, the original dates on which the trap was issued, rather than the current dates
are used.
•
If the specified sequence number is lower than the oldest trap sequence number stored in the switch,
the switch replays all stored traps.
•
If the specified sequence number is equal to or greater than the oldest trap sequence number stored, the
switch replays all stored traps from the specified sequence number up to the latest sequence number.
•
If the specified sequence number is greater than the latest sequence number, no traps are replayed..
Examples
-> snmp trap replay 172.12.2.100
-> snmp trap replay 300::1