Alcatel-Lucent OmniSwitch 6250, Cli Reference Manual, Page: 945 / 2018

Ethernet OAM Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 25-33
ethoam fault-reset-time
Configures the timer value for the Fault Notification Generation Reset time that specifies the time inter-
val, during which the fault alarm is re-enabled to process faults. The fault alarm will only be re-enabled if
no new faults are received during this time interval.
ethoam fault-reset-time centiseconds endpoint endpoint_id domain {mac_address | domain_name}
association association_name
no ethoam fault-reset-time endpoint endpoint_id domain {mac_address | domain_name} association
association_name
Syntax Definitions
centiseconds The Fault Notification Generation Reset timer value, in centi seconds.
The valid range is 250–1000.
endpoint_id Specifies the MEP of a specific MA. The valid range is 1–8191.
mac_address Specifies the CFM system MAC address.
domain_name Specifies the domain name. For more information on the different
formats of the domain name, refer to
ethoam domain command on
page 25-3 .
association_name Name of the Ethernet OAM Association. Up to 48 (minus the domain
name length) characters may be used.
Defaults
Platforms Supported
OmniSwitch 6250-Metro Models
Usage Guidelines
•
Use the no form of this command to to restore the Fault Notification Generation Reset timeout value to
its default value.
•
The Fault Notification Generation Reset timer value is configurable per MEP.
Examples
-> ethoam fault-reset-time 10 end-point 100 domain esd.alcatel-lucent.com associa-
tion alcatel_sales
-> no ethoam fault-reset-time end-point 100 domain esd.alcatel-lucent.com associa-
tion alcatel_sales
parameter default
centiseconds 1000