Alcatel-Lucent OmniSwitch 6250, Cli Reference Manual, Page: 630 / 2018

Source Learning Commands
page 18-2 OmniSwitch 6250 CLI Reference Guide November 2009
mac-address-table
Configures a destination unicast MAC address. The configured (static) MAC address is assigned to a non-
mobile switch port or link aggregate ID and VLAN. Packets received on ports associated with the speci-
fied VLAN that contain a destination MAC address that matches the static MAC address are forwarded to
the specified port. Static destination MAC addresses are maintained in the Source Learning MAC address
table.
mac-address-table [permanent] mac_address {slot/port | linkagg link_agg} vid [bridging | filtering]
no mac-address-table [permanent | learned] [mac_address {slot/port | linkagg link_agg} vid]
Syntax Definitions
permanent Defines a permanent static MAC Address that is not removed when the
switch reboots.
learned Specifies that the MAC address is a dynamically learned address.
mac_address Enter the destination MAC Address to add to the MAC Address Table
(e.g., 00:00:39:59:f1:0c).
slot/port Enter the slot number for the module and the physical port number on
that module (e.g., 3/1 specifies port 1 on slot 3).
link_agg Enter a link aggregate ID number (0–31). See Chapter 12, “Link Aggre-
gation Commands.”
vid VLAN ID number (1–4094).
bridging Specifies that all packets to or from this MAC address are bridged.
filtering Specifies that all packets to or from this MAC address are dropped.
Defaults
Platforms Supported
OmniSwitch 6250
Usage Guidelines
•
Use the no form of this command to remove a MAC address from the Source Learning MAC Address
Table.
•
The specified slot/port or link aggregate ID must already belong to the specified VLAN. Use the vlan
port default command to assign a port or link aggregate ID to a VLAN before you configure the static
MAC address. Only traffic from other ports associated with the same VLAN is directed to the static
MAC address slot/port.
parameter default
permanent permanent
bridging | filtering bridging