Alcatel-Lucent OmniSwitch 6250, Cli Reference Manual, Page: 1225 / 2018

IPv6 Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 30-59
ipv6 access-list address
Adds IPv6 addresses to the specified IPv6 access list.
ipv6 access-list access-list-name address address/prefixLen [action {permit | deny}]
[redist-control {all-subnets | no-subnets | aggregate}]
no ipv6 access-list access-list-name address address/prefixLen
Syntax Definitions
access-list-name Name of the IPv6 access list (up to 20 characters).
address/prefixLen IPv6 address along with the prefix length to be added to the access list.
permit Permits the IPv6 address for redistribution.
deny Denies the IPv6 address for redistribution.
all-subnets Redistributes or denies all the subnet routes that match the network
portion of the IP address as specified by the mask length.
no-subnets Redistributes or denies only those routes that exactly match the IP
address and the mask length.
aggregate Redistributes an aggregate route if there are one or more routes that
match or are subnets of this address.
Defaults
Platforms Supported
OmniSwitch 6250
Usage Guidelines
•
Use the no form of this command to delete the address from the access list.
•
The access-list-name should exist before you add multiple IPv6 addresses to the IPv6 access list.
•
The action parameters ( permit and deny ) determine if a route that matches the redist-control configu-
ration for the IP address is allowed or denied redistribution.
•
The redist-control parameters ( all-subnets, no-subnets , and aggregate ) defines the criteria used to
determine if a route matches an address in the access list.
•
Note that configuring the combination of redist-control aggregate with action deny is not allowed.
parameter default
permit | deny permit
all-subnets | no-subnets |
aggregate all-subnets