Alcatel-Lucent OmniSwitch 6250, Cli Reference Manual, Page: 123 / 2018

OmniSwitch 6250 CLI Reference Guide November 2009 page 4-1
4 Power over Ethernet (PoE)
Commands
The Power over Ethernet (PoE) feature is supported on the OmniSwitch 6250-P24 switch. Refer to the
OmniSwitch 6250 Hardware Users Guide and OmniSwitch 6250 Hardware Users Guide for further
details.
Note on Terminology . There are several general terms used to describe this feature. The terms Power
over Ethernet (PoE) , Power over LAN (PoL), Power on LAN (PoL) , and Inline Power are synonymous
terms used to describe the powering of attached devices via Ethernet ports. For consistency, this chapter
and the
OmniSwitch 6250 CLI Reference Guide refer to the feature as Power over Ethernet (PoE) .
Additional terms, such as Powered Device (PD) and Power Source Equipment (PSE) are terms that are not
synonymous, but are directly related to PoE.
•
PD refers to any attached device that uses a PoE data cable as its only source of power. Examples
include access points such as IP telephones, Ethernet hubs, wireless LAN stations, etc.
•
PSE refers to the actual hardware source of the electrical current for PoE. In the case of OS6250-P24-
Enterprise Model, the PSE is contained within the chassis and can be augmented by the backup inline
power supply.
PoE commands documented in this section comply with IEEE 802.3 and 802.af.
MIB information for the PoE commands is as follows:
Filename: AlcatelIND1InLinePowerEthernet_mib
Module: ALCATEL-IND1-INLINE-POWER-MIB
Filename: AaIETF_HUBMIB_POWER_ETHERNET_DRAFT_mib
Module: POWER-ETHERNET-MIB
A summary of the available commands is listed here:
lanpower start
lanpower stop
lanpower power
lanpower maxpower
lanpower priority
lanpower priority-disconnect
lanpower combo-port
lanpower capacitor-detection
lanpower combo-port
show lanpower capacitor-detection
show lanpower priority-disconnect