Alcatel-Lucent OmniSwitch 6250, Cli Reference Manual, Page: 1779 / 2018

IP Multicast Switching Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 41-61
ipv6 multicast querying
Enables or disables MLD querying on the specified VLAN or on the system if no VLAN is specified.
ipv6 multicast [vlan vid] querying [{enable | disable}]
no ipv6 multicast [vlan vid] querying
Syntax Definitions
vid VLAN on which to apply the configuration.
enable Enable MLD querying.
disable Disable MLD querying.
Defaults
Platforms Supported
OmniSwitch 6250
Usage Guidelines
•
Use the no form of this command to remove an MLD querying entry on the specified VLAN or on the
system and return to its default behavior.
•
IPv6 Multicast Switching and Routing must be enabled to enable MLD querying on the system and/or
specified VLANs.
•
If the MLD querying is already enabled/disabled on the system, then the VLAN configuration will
override the system's configuration.
•
MLD querying refers to requesting the network's MLD group membership information by sending out
MLD queries. MLD querying also involves participating in MLD querier election.
•
You can also restore the MLD querying to its default (i.e., disabled) setting on the system if no VLAN
is specified, by using only
ipv6 multicast querying (e.g., ipv6 multicast querying).
•
You can also restore the MLD querying to its default (i.e., disabled) setting on the specified VLAN, by
using only
ipv6 multicast vlan vid querying (e.g., ipv6 multicast vlan 2 querying).
Examples
-> ipv6 multicast querying enable
-> ipv6 multicast querying disable
-> ipv6 multicast querying
-> ipv6 multicast vlan 2 querying enable
-> ipv6 multicast vlan 2 querying disable
-> ipv6 multicast vlan 2 querying
-> no ipv6 multicast vlan 2 querying
parameter default
enable | disable disable