Alcatel-Lucent OmniSwitch 6250, Cli Reference Manual, Page: 812 / 2018

VLAN Management Commands
page 22-12 OmniSwitch 6250 CLI Reference Guide November 2009
show vlan
Displays a list of VLANs configured on the switch.
show vlan [vid]
Syntax Definitions
vid VLAN ID number (1–4094).
Defaults
By default, a list of all VLANs is displayed.
Platforms Supported
OmniSwitch 6250
Usage Guidelines
•
Specify a VLAN ID with this command to display information about a specific VLAN.
•
Note that specifying a range of VLAN IDs is also allowed. Use a hyphen to indicate a contiguous range
(e.g., show vlan 10-15). Note that only one VLAN entry—a single VLAN ID or a range of VLAN
IDs— is allowed with this command. Multiple entries are not accepted.
Examples
-> show vlan
stree mble src
vlan type admin oper 1x1 flat auth ip tag lrn name
-----+-----+------+-----+----+-----+----+-----+ ----+-----+---------
1 std on on on on off off off on VLAN 1
100 vstk on off off on off off off off VLAN 100
-> show vlan 1
Name : VLAN 1,
Administrative State: enabled,
Operational State : enabled,
1x1 Spanning Tree State : enabled,
Flat Spanning Tree State : enabled,
IP Router Port : off,
Mobile Tag : off,
Source Learning : enabled
-> show vlan 100
Name : VLAN 100,
Administrative State: enabled,
Operational State : disabled,
1x1 Spanning Tree State : disabled,
Flat Spanning Tree State : enabled,
IP Router Port : off,
IP MTU : 1500,