Alcatel-Lucent OmniSwitch 6250, Cli Reference Manual, Page: 505 / 2018

Distributed Spanning Tree Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 16-65
bridge 1x1 slot/port priority
Configures the Spanning Tree priority value for a port or an aggregate of ports for the specified 1x1 mode
VLAN instance. The Spanning Tree algorithm uses the port priority value to determine the most favor-
able port when a bridge has multiple ports with the same path cost to the root bridge.
bridge 1x1 vid {slot/port | logical_port} priority priority
Syntax Definitions
vid An existing VLAN ID number (1–4094).
slot/port Enter the slot number for the module and the physical port number on
that module (e.g., 3/1 specifies port 1 on slot 3).
logical_port Link aggregate ID number (0–31).
priority Port priority value (0–15). The lower the number, the higher the
priority.
Defaults
By default, the bridge port priority value is set to 7.
Platforms Supported
OmniSwitch 6250
Usage Guidelines
•
The port priority specifies the value of the priority field contained in the first byte of the Port ID. The
second byte contains the physical switch port number.
•
This command is an explicit Spanning Tree command that only applies to the specified VLAN instance
regardless of which operating mode (flat or 1x1) or protocol is active on the switch.
•
If the switch is running in the flat mode when this command is used, the specified priority value for the
port is not active for the specified VLAN instance until the operating mode for the switch is changed to
the 1x1 mode.
•
Note that when a configuration snapshot is taken of the switch, all Spanning Tree commands are saved
in their explicit format.
Examples
-> bridge mode flat
-> bridge 1x1 100 4/1 priority 2
-> bridge 1x1 200 1/24 priority 4
-> bridge mode 1x1
-> bridge 1x1 255 5/10 priority 1
-> bridge 1x1 455 1/16 priority 15