Alcatel-Lucent OmniSwitch 6250, Cli Reference Manual, Page: 1064 / 2018

IP Commands
page 29-16 OmniSwitch 6250 CLI Reference Guide November 2009
traceroute
Finds the path taken by an IP packet from the local switch to a specified destination. This command
displays the individual hops to the destination as well as some timing information.
traceroute {ip_address | hostname} [max-hop max_hop_count]
Syntax Definitions
ip_address IP address of the host whose route you want to trace.
hostname DNS name of the host whose route you want to trace.
max_hop_value Maximum hop count for the trace.
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
•
When using this command, you must enter the name of the destination as part of the command line
(either the IP address or host name).
•
Use the optional max-hop parameter to set a maximum hop count to the destination. If the trace
reaches this maximum hop count without reaching the destination, the trace stops.
Examples
-> traceroute 128.251.17.224
traceroute to 128.251.17.224, 30 hops max, 40 byte packets
1 10.255.11.254 0 ms 0 ms 0 ms
2 172.23.0.251 0 ms 16.6667 ms 0 ms
3 128.251.14.253 0 ms 0 ms 0 ms
4 128.251.17.224 0 ms 0 ms 0 ms
-> traceroute 128.251.17.224 max-hop 3
traceroute to 128.251.17.224, 3 hops max, 40 byte packets
1 10.255.11.254 0 ms 0 ms 0 ms
2 172.23.0.251 16.6667 ms 0 ms 0 ms
3 128.251.14.253 0 ms 0 ms 0 ms
Release History
Release 6.6.1; command was introduced.