Alcatel-Lucent OmniSwitch 6250, Cli Reference Manual, Page: 668 / 2018

Learned Port Security Commands
page 19-20 OmniSwitch 6250 CLI Reference Guide November 2009
show port-security
Displays Learned Port Security (LPS) configuration and table entries.
show port-security [slot/port[-port2] | slot]
Syntax Definitions
slot/port The slot number for the module and the physical port number on that
module (e.g., 3/1 specifies port 1 on slot 3).
-port2 The last port number in a range of ports you want to configure on the
same slot (e.g, 3/1-4 specifies ports 1-4 on slot 3).
slot Enter the slot number for a module to specify that the command should
include all ports on that module (e.g., 6 specifies all ports on the module
found in slot 6 of the switch chassis).
Defaults
By default, all ports with an LPS configuration are displayed.
Platforms Supported
OmniSwitch 6250
Usage Guidelines
•
Displays ports that have an LPS configuration, even if LPS is disabled on the port.
•
Use the slot/port[-port2] parameter with this command to display the LPS configuration for a specific
port or a range of ports.
•
Use the slot parameter with this command to display the LPS configuration for all the ports on a
specific slot.
•
In addition, MAC addresses that were learned on the LPS port because they fell within the specified
MAC address range, appear as a separate entry in the LPS table with a dynamic MAC type.
•
Dynamic MAC addresses become configured MAC addresses in the LPS table when the switch config-
uration is saved and the switch is rebooted. If the configuration is not saved before the next reboot, all
dynamic MAC addresses are cleared from the LPS table.
•
The MAC Type field is blank if an authorized MAC address range is configured for the LPS port.