Alcatel-Lucent OmniSwitch 6250, Cli Reference Manual, Page: 638 / 2018

Source Learning Commands
page 18-10 OmniSwitch 6250 CLI Reference Guide November 2009
show mac-address-table
Displays Source Learning MAC Address Table information.
show mac-address-table [permanent | learned] [mac_address] [slot slot | slot/port] [linkagg link_agg]
[vid | vid1-vid2]
Syntax Definitions
permanent Display static MAC addresses with a permanent status.
learned Display dynamically learned MAC addresses.
mac_address Enter a MAC Address (e.g., 00:00:39:59:f1:0c).
slot Enter the slot number for a module to specify that the command should
include all ports on that module (e.g., 6 specifies all ports on the module
found in slot 6 of the switch chassis).
slot/port Enter the slot number and the physical port number on that module
(e.g., 3/1 specifies port 1 on slot 3).
link_agg Enter a link aggregate ID number (0–31). See Chapter 12, “Link Aggre-
gation Commands.”
vid A single VLAN ID number (1–4094).
vid1-vid2 A contiguous range of VLAN ID numbers (e.g., 5-10).
Defaults
By default, information is displayed for all MAC addresses contained in the table.
Platforms Supported
OmniSwitch 6250
Usage Guidelines
•
Note that only one VLAN entry—a single VLAN ID or a range of VLAN IDs— is allowed with this
command. Multiple entries are not accepted.
•
If a static MAC address is configured on a port link that is down or disabled, an asterisk appears to the
right of the MAC address in the
show mac-address-table command display. The asterisk indicates that
this is an invalid MAC address. When the port link comes up, however, the MAC address is then
considered valid and the asterisk no longer appears next to the address in the display.