Alcatel-Lucent OmniSwitch 6250, Cli Reference Manual, Page: 1112 / 2018

IP Commands
page 29-64 OmniSwitch 6250 CLI Reference Guide November 2009
icmp echo
Enables or disables ICMP echo messages, and sets the minimum packet gap. The minimum packet gap is
the number of microseconds that must pass between ICMP messages of the same type.
icmp echo [request | reply] {{enable | disable} | min-pkt-gap gap}
Syntax Definitions
request Specifies the echo request ICMP message.
reply Specifies the echo reply ICMP message.
enable Enables the specified ICMP message.
disable Disables the specified ICMP message.
gap The number of microseconds required between ICMP messages of this
type.
Defaults
Platforms Supported
OmniSwitch 6250
Usage Guidelines
•
This command sets the ICMP echo messages. An echo request is sent to a destination, and must be
responded to with an echo reply message that contains the original echo request.
•
Using this command without specifying a request or reply will enable, disable, or set the minimum
packet gap for both types.
•
The echo ICMP messages can also be enabled, disabled, and modified using the icmp type command.
See the icmp type command information on the type and code for the echo ICMP messages.
Examples
-> icmp echo reply enable
-> icmp echo enable
-> icmp echo request enable
-> icmp echo request min-pkt-gap 50
Release History
Release 6.6.1; command was introduced.
parameter default
enable | disable enable
gap 0