Alcatel-Lucent OmniSwitch 6250, Cli Reference Manual, Page: 1656 / 2018

QoS Policy Commands
page 39-160 OmniSwitch CLI Reference Guide November 2009
show policy classify destination interface type
Specifies a destination interface type for a hypothetical packet to show how the QoS software in the switch
will handle the packet.
show policy classify {l2 | l3 | multicast} [applied] destination interface type {ethernet | wan | ethernet-
10 | ethernet-100 | ethernet-1G | ethernet-10G}
Syntax Definitions
l2 Uses the Layer 2 classifier for the hypothetical packet.
l3 Uses the Layer 3 classifier for the hypothetical packet.
multicast Uses the multicast IGMP classifier for the hypothetical packet.
applied Indicates that only applied policies should be examined.
ethernet Indicates that the flow’s destination port is an Ethernet interface.
wan Indicates that the flow’s destination port is a WAN interface. Not
supported currently.
ethernet-10 Indicates that the flow’s destination port is 10 Mb Ethernet.
ethernet-100 Indicates that the flow’s destination port is 100 Mb Ethernet.
ethernet-1G Indicates that the flow’s destination port is 1 gigabit Ethernet.
ethernet-10G Indicates that the flow’s destination port is 10 gigabit Ethernet.
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
•
Use this command to determine if the switch will classify the traffic condition specified and match it to
a policy. By default the classifier only tests pending policies (policies that have not yet been applied).
Use the
applied keyword to test only those policies that have been applied.
•
Use the qos apply command to activate saved policies.
Examples
-> show policy classify l2 destination interface type ethernet-10
See the output example given on page 39-143 for more information about the potential screen display.
Release History
Release 6.6.1; command was introduced.