Alcatel-Lucent OmniSwitch 6250, Cli Reference Manual, Page: 702 / 2018

Ethernet Port Commands
page 20-30 OmniSwitch 6250 CLI Reference Guide November 2009
interfaces hybrid duplex
Configures duplex mode on combo ports. In full duplex mode, the interface transmits and receives data
simultaneously. In half duplex mode, the interface can transmit
or receive data at a given time. Auto
duplex setting causes the switch to advertise all available duplex modes (half/full/both) for the port during
autonegotiation.
interfaces slot[/port[-port2]] hybrid {fiber | copper} duplex {full | half | auto}
Syntax Definitions
slot Slot number you want to configure.
port Port number of the interface you want to configure.
port2 Last port number in a range of ports you want to configure.
fiber Specifies that configuration changes will be made to the SFP port(s).
copper Specifies that changes will be made to the copper RJ-45 port(s).
full Sets interface to full duplex mode.
half Sets interface to half duplex mode.
auto Switch will automatically set both the duplex mode settings to auto-
negotiation.
Defaults
Platforms Supported
OmniSwitch 6250
Usage Guidelines
The MIB table and MIB object listed in the “MIB Objects” section below apply to the inactive configured
media only. See the “MIB Objects” section in the
interfaces duplex section for the MIB table and MIB
object for the active configured media.
Examples
-> interfaces 1/25 hybrid copper duplex auto
-> interfaces 1/25-26 hybrid copper duplex half
-> interfaces 1 hybrid copper fiber full
Release History
Release 6.6.1; command was introduced.
parameter default
full | half | auto auto