Alcatel-Lucent OmniSwitch 6250, Cli Reference Manual, Page: 1644 / 2018

QoS Policy Commands
page 39-148 OmniSwitch CLI Reference Guide November 2009
show policy classify destination port
Specifies a destination port for a hypothetical packet to show how the QoS software in the switch will
handle the packet.
show policy classify {l2 | l3 | multicast} [applied] destination port slot/port
Syntax Definitions
l2 Uses the Layer 2 classifier for the hypothetical packet.
l3 Uses the Layer 3 classifier for the hypothetical packet.
multicast Uses the multicast IGMP classifier for the hypothetical packet.
applied Indicates that only applied policies should be examined.
slot/port The slot and port number of the destination address of the flow.
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
•
Use this command to determine if the switch will classify the traffic condition specified and match it to
a policy. By default the classifier only tests pending policies (policies that have not yet been applied).
Use the
applied keyword to test only those policies that have been applied.
•
Use the qos apply command to activate saved policies.
Examples
-> show policy classify l2 destination port 2/1
See the output example given on page 39-143 for more information about the potential screen display.
Release History
Release 6.6.1; command was introduced.
Related Commands
qos apply Applies configured QoS and policy settings to the current configuration.
show policy classify Describes the base command.