Alcatel-Lucent OmniSwitch 6250, Cli Reference Manual, Page: 293 / 2018

Configuration File Manager Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 9-13
show configuration snapshot
Displays the switch’s current running configuration for all features or for the specified feature(s).
show configuration snapshot [feature_list]
Syntax Definitions
feature_list Specify the feature(s) for which you want to display the running config-
uration. List the features separated by a space with no comma.
Defaults
By default, this command shows configuration information for all features.
Platforms Supported
OmniSwitch 6250
Usage Guidelines
•
Use this command to view the current configuration for any feature shown in the table.
•
To show a list of features on the switch, use the show configuration snapshot ? syntax.
•
Configurations are listed below the name of each feature.
•
Features with no current configuration show only the name of the feature.
snapshot-supported features
802.1q ip-helper policy
aaa ip-routing qos
aip ipmr rdp
all ipms rip
bridge ipv6 ripng
chassis linkagg session
efm-oam loopback-detection snmp
ethernet-oam module stack-manager
health ntp stp
interface port-mapping vlan
ip pmm